Filter
Top Products
125
How to operate the Sound Adjustment Mode
IX
Multi-harmonizer
When original sounds are converted to MP3/WMA and Memory
Stick (ATRAC3) format, frequency ranges that are not normally
audible to the human ear are compressed. The multi-harmonizer
can be used to play back these compressed sounds at as close to
their original form as possible so that clear and powerful sound can
be enjoyed.
Non-fader phase
The sounds that are output from woofers include sounds that are in
the same frequency ranges that are output from the front and rear
speakers, and under the various conditions that can occur inside
vehicle compartments, some of these sounds may cancel each
other out. This phenomenon can be eliminated by changing the
phase of the woofer.
The phase of the woofer can be set to normal timing (in which the
output timing between the front and rear speakers and the woofer is
the same) or reverse timing (in which the output timing between the
front and rear speakers and the woofer is different), depending on
the vehicle compartment conditions.
Non-Fader output
Depending on your external amplifier, non-fader output may be
stereo or mono.
Speaker layout
The speaker layout can be configured as a 3-way or 4-speaker
system.
E-iSERV sound effect customizations
The parametric equalizer, time alignment, and crossover setting can
be adjusted using this deck, or through the Eclipse web site.
(Settings can be stored on CD-R or Memory Stick.)
CD8455.book 125 ページ ２００４年１２月１１日 土曜日 午後７時２４分