Filter
Top Products
11
10. Use the EBL offset feature to anchor the net cursor at net origin point.
1) Push the EBL OFFSET key.
2) Use the trackball to set net origin point.
3) Press the EBL OFFSET key to anchor the net cursor.
11. Steer the vessel so your ship’s trail runs along the net cursor then throw the net.
2.3 Cursor Data Display
The cursor data box, which is located at the top right corner on the screen, can show
latitude and longitude position of the cursor, X- and Y-coordinates, and range and
bearing from your ship to the cursor. Further, if set and drift corrections are disabled,
two cursor data boxes may be shown, to display two sets of position information.
Left-click the cursor data box successively to change cursor data in the sequence
shown below.
+
0.280 NM
0.374 NM
+
36°23.693 N
138°31.377 E
Latitude and longitude
X-Y coordinate
X-coordinate
(Starboard: plus, Port: minus)
036.7°T
0.466 NM
Range and bearing from
own ship
00:01
TTG to
cursor position
+
Y-coordinate (bow)
(Upward: plus, Downward: minus)