Filter
Top Products
19
NAV DATA-1, -2: Choose the number of
navigation data items to display on the
nav data displays, from two, three or
four items. Requires appropriate nav
data.
WATER TYPE: Choose the water type
with which to use the LS-4100, from
Salt or Fresh.
KEY BEEP: Turn key beep on or off.
BATT VOLTAGE: Turn the battery
voltage indication (appears at the top
right corner on the screen) on or off.
When on it replaces the picture advance
speed indication.
Page 2
NAV DISPLAY: Choose the nav data to
display in the nav data window at the
top left-hand corner. You may choose
from temperature/speed,
latitude/longitude, range and bearing,
course over ground, trip distance or
wind speed. Requires appropriate nav
data.
40.7°F
16.2kt
Nav window
NMEA0183: Choose NMEA version of
navigator; Ver. 1.5, Ver. 2.0 or Ver. 3.0.
TLL OUTPUT: Enables/disables output
of TLL (Target Latitude, Longitude)
position when the [MARK] key is
operated. “TLL” outputs latitude and
longitude position. “FURUNO-TLL,”
available with connection of navigator
that can output FURUNO TLL, outputs
latitude and longitude, water
temperature, depth, etc.
BEARING: Ship’s course and bearing
to a waypoint may be displayed in true
or magnetic bearing. Magnetic bearing
is true bearing plus (or minus) earth’s
magnetic deviation. Requires bearing
data.
WIND SPD/DIR: Choose the wind
speed and direction reference from true
and apparent. Requires wind sensor.
Apparent: The direction (in relation to
ship’s bow) and speed of the wind as it
appears to those on board, relative to
the speed and direction of the boat;
combination of the true wind and the
wind caused by the boat's movement.
True: The speed and direction (in
relation to ship’s bow) of the wind felt or
measured when stationary.
TRIP SOURCE: Choose speed source
for the trip distance indication; Own
(transducer with speed sensor or
separate speed sensor) or NMEA.
TEMP SOURCE: Choose source of
water temperature input; Off, Own
(transducer with water temperature
sensor or separate temperature sensor),
or NMEA.
SPEED SOURCE: Choose source of
speed input; Off, Own (transducer with
speed sensor or separate speed
sensor), or NMEA. Requires speed
data.
TEMP CALIB.: If the water temperature
sensor-generated water temperature
indication is wrong, you can correct it
here, when “Own” is selected as
temperature source. For example, if the
water temperature indication is 2°
higher than actual water temperature,
enter -2. The setting range is -40°F to
+40°F.