Filter
Top Products
Setup
6 312497G
Filling Master Divider Valve
Refer to FIG. 5. when performing this procedure.
1. Verify that all port plugs or performance indicators
have been removed from all indicator ports in the
master divider valve.
2. Verify that the system pump is properly connected
to the inlet port of the master divider valve.
3. Cycle the system pump sufficiently to fill the main
feeder line between the pump and the master
divider valve and the lubricant is observed being
discharged from all of the indicator ports on the front
of the master divider valve with no evidence of
included air.
4. Reinstall the master divider valve port plugs or per-
formance indicators into their respective positions.
FIG. 5
TI11000
MASTER
BLEED
SECONDARY
LUBE POINT
HERE
CYCLE PUMP