Filter
Top Products
33
ENGLISH
iPod/iPhone MODE
-------------------------------------------------------------------------------------------------
The device features an iPod/iPhone dock which
allows you to play digital audio files and video
sound tracks stored on your iPod/iPhone using
the device’s speaker.
Notes:
7
The device is able to recharge the internal
battery of your iPod/iPhone. In standby
mode, the device cannot recharge iPod/
iPhone because of minimised power con-
sumption. If you need to recharge your
iPod/iPhone, please power up the device.
7
Your iPod/iPhone will use its backlight set-
tings as configured. If these need changing,
use the Settings menu on your iPod/iPhone.
7
Using the buttons of the remote control and
the menus of the iPod/iPhone, you can se-
lect the existing structures (Playlists, Artists,
Albums, etc.) and tracks.
Supported iPod/iPhone models
The software is made to support the following
iPod/iPhone models:
– iPod touch (4th Generation)
– iPod touch (3rd Generation)
– iPod touch (2nd Generation)
– iPod touch (1st Generation)
– iPod classic
– iPod with video
– iPod nano (6th Generation)
– iPod nano (5th Generation)
– iPod nano (4th Generation)
– iPod nano (3rd Generation)
– iPod nano (2nd Generation)
– iPod nano (1st Generation)
– iPod mini
– iPod photo
– iPod (5th Generation)
– iPod (4th Generation)
– iPhone 4
– iPhone 3GS
– iPhone 3G
– iPhone
Playing the contents of an iPod/
iPhone
1 Open the »iPod dock drawer« by pressing
on it.
2 Connect your iPod/iPhone into the »iPod
dock connector« until it latches into place
(see the “Connecting the iPod/iPhone” sec-
tion).
3 Switch on the device from standby mode by
pressing »8« on the remote control or using
»ON/OFF« on the device.
– If the device is in Internet radio, Music play-
er, FM or Aux In mode, the display shows:
»iPod attached- Switch to iPod mode?«
Time/Date
iPod
YES NO
iPod attached -
Switch to iPod mode?
4 Confirm by pressing »YES« using the Jog-Shuttle
or »OK« on the remote control.
Note:
7
If you do not make your selection within a
few seconds, this message disappears. You
can then select iPod mode by using the
»MODE« button.
7
Press »M« repeatedly on the remote control
or »MODE« on the device until »iPod« ap-
pears on display.
– Display: »Docked« appears after connec-
tion and playback starts automatically with
the last played passage.
5 To pause playback, press » «.
6 To resume playback, press » « again.
7 Press »
7
« on the remote control to stop play-
back.