Filter
Top Products
73
Lat/Lon Grid
Lat/Lon Grid allows you to display or hide a grid showing
latitude and longitude lines.
To change the Lat/Lon Grid setting:
1. Highlight Lat/Lon Grid on the Chart main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Lat/Lon Grid setting.
(Hidden, Visible, Default = Hidden)
Spot Soundings
Spot Soundings allows you to display or hide spot soundings,
which are depth measurements shown on the chart.
NOTE: Spot Soundings are only available with optional-purchase MMC/SD cards.
To change the Spot Soundings setting:
1. Highlight Spot Soundings on the Chart main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Spot Soundings setting.
(Hidden, Visible, Default = Hidden)
Set Simulation Position
(Advanced)
Set Simulation Position allows you to set the position of the boat used in the Simulator. The Set
Simulation Position menu choice is only available when User Mode is set to Advanced (see Setup
Menu Tab: User Mode).
To set the Simulation Position:
1. Activate the cursor and move it to the coordinates from where you want the simulation
to start.
NOTE: The cursor must be active in order for this procedure to work.
2. Make sure you are in Advanced User Mode, then highlight Set Simulation Position on the
Chart main menu.
3. Use the RIGHT 4-WAY Cursor Control key to change the Simulation Position setting. A
confirmation dialog box will appear to allow you to change your mind, or to confirm your
choice. If the cursor was not active before you began this procedure, you will see an error
message. Exit the menu, set the cursor, then try again.