Filter
Top Products
Side View
(WideSide® Transducer: WideSide® View Only)
Side View sets which transducer beam from the WideSide® Transducer is shown in the WideSide® View.
A WideSide® transducer must be connected to the Matrix™ Fishing System. The Side View menu choice
is available when Transducer Select is set to WideSide® (see Sonar Menu Tab: Transducer Select) and can
only be accessed from the Sonar X-Press™ menu when you are in WideSide® view.
NOTE: The WideSide® View requires the purchase of the WideSide® transducer. You can visit our
website at www.humminbird.comto order this accessory online or contact our Customer Resource
Center at 1-800-633-1468.
To adjust the Side View:
1. Make sure you are in WideSide® Transducer Mode and that a WideSide® transducer is
connected, then highlight Side View on the Sonar X-Press™ menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Side View setting.
(L [Left], Both, R [Right], Default = Both)
Sensitivity
Sensitivity controls how much detail is shown on the display.
Increasing the sensitivity shows more sonar returns from small baitfish and suspended debris in the
water; however, the display may become too cluttered. When operating in very clear water or greater
depths, increased sensitivity shows weaker returns that may be of interest. Decreasing the sensitivity
eliminates the clutter from the display that is sometimes present in murky or muddy water. If
Sensitivity is adjusted too low, the display may not show many sonar returns that could be fish.
T
o adjust the Sensitivity:
1. Highlight Sensitivity on the Sonar X-Press™ menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to increase or decrease the Sensitivity
setting. (Low = 1, High = 20, Default = 10)
Sensitivity at Medium Sensitivity at HighSensitivity at Low
36
Sonar X-Press™ Menu
(Sonar Views Only)
The Sonar X-Press™ Menu provides access to the settings most
frequently-used. Press the MENU key once while in any of the
Sonar Views to access the Sonar X-Press™ Menu.
NOTE:Menu choices will vary depending on system settings such as
whether the unit is set for Advanced User mode or what transducer
is currently selected.
Sonar X-Press™ Menu
37
M87_Man_531352-1_A.qxd 12/9/2004 3:28 PM Page 42