Filter
Top Products
12 Intel Server RAID Controller U3-1 (SRCU31)
Quick Start Guide
Setup and Installation for Novell NetWare
Software Requirements
• SRCU31 CD-ROM
• Hard disk space: minimum 4 MB
• MS-DOS
†
5.x or later (Novell 4.2 only)
• SRCU31 NetWare Installation Diskette (one blank high density floppy
diskette required)
• Novell NetWare
†
4.2 with Service Pack 8a or higher or Novell NetWare
5.0 or 5.1 with Service Pack 4 or higher*
* Not supplied
Installing Novell NetWare on a RAID Volume
There are two procedures listed below (one for each supported version of
NetWare). Please follow the instructions for the version you wish to install
(version 4.2 or 5.0 and 5.1).
NetWare 4.2
1 Create a SRCU31 NetWare Installation Diskette.
a. Insert the Intel Integrated RAID CD-ROM into the target system and
restart the system to boot from the CD-ROM.
b. When the ROM-DOS Startup Menu appears select option #1, Make
Diskettes.
c. When the Select a diskette to create screen appears, select NetWare
Installation. A command window appears.
d. Insert a blank high-density diskette in drive A: and press Enter to
create the SRCU31 NetWare Installation Diskette. Alternatively, the
CD-ROM can be inserted into a different system running
Windows 95, 98 or NT. The CD-ROM’s auto-run feature will bring
up a menu that will allow creation of the SRCU31 NetWare
Installation Diskette.
2 Insert the NetWare Installation CD-ROM, reboot the server, go to the
appropriate drive letter and begin the NetWare 4.2 installation.
3 When the device driver installation screen appears, Select additional or
modify selected Disk / LAN drivers.
4 Choose Select an additional driver. Select Insert to install an unlisted
driver. Ensure that the SRCU31 NetWare Installation diskette (created in
Step 1) is in the floppy drive and press Enter. Select BKSTROSM.HAM
from the list.
5 Continue with the NetWare installation as normal by following the screen
prompts.
6 Once the server installation is finished, complete the installation of the Intel
Integrated RAID software suite by following the steps below.
7 Run LOAD INSTALL.