Filter
Top Products
14 Intel Server RAID Controller U3-1 (SRCU31)
Quick Start Guide
5 It will eventually load a Welcome screen, asking you to verify the startup
directory (C:\NWSERVER). Press Alt F10 to exit the installation. At the
console, type Down. The installation exits to the boot drive prompt.
6 Insert the SRCU31 NetWare installation diskette created in Step 1 into the
A: drive. If your boot drive is C:, then run NWUPDATE.BAT. If your boot
drive is other than C:, then create an NWUPDATE subdirectory and copy
all the files from A:\DRIVERS into the NWUPDATE subdirectory.
7 Remove the diskette from the A: drive and reboot the server. After booting
you will be asked to accept the license agreement. Do so and then select
Continue with Existing Partition. You are now ready to install NetWare 5
on the Intel Integrated RAID volume.
8 Continue with the NetWare installation as normal by following the screen
prompts. Select the Block Storage OSM when prompted.
9 Reboot the server and install Service Pack 4 or higher. Once the server
installation is completed, reboot the server.
10 To install the Intel Integrated RAID software (run the Intel Integrated
RAID setup) run NWCONFIG.
11 Select Product Options, then Install product not listed. It will tell you that
it is going to scan the A: drive for installation scripts. Ensure the SRCU31
NetWare Installation diskette is in the floppy drive, press Enter to continue.
12 A screen prompt will ask which components (see below) you wish to
install. Select the following components and press F10 to continue. See
figure below.
BKSTROSM.HAM
HTTP and Winsock Services
RAID Management Agents
Preselect Components
The appropriate files are copied and the AUTOEXEC.NCF and
STARTUP.NCF files are modified as necessary.