Filter
Top Products
Intel Server RAID Controller U3-1 (SRCU31) 7
Quick Start Guide
Intel Server RAID Controller U3-1 Hardware
Setup
Hardware Requirements
• Server with CD-ROM Drive (not attached to Intel Server RAID
Controller U3-1)
• One available PCI slot (64 bit, 33 MHz recommended)
• Monitor display resolution of 800 x 600 or higher (recommended)
• Intel Server RAID Controller U3-1 Adapter Card
• PCI 2.2 Compliant System BIOS
• Memory: SDRAM DIMM ECC unless already installed. See supported
parts at
http:// support.intel.com/support/motherboards/server/srcu31
Installing Intel Server RAID Controller U3-1 into a System
The SRCU31 comes with the Intel Integrated RAID firmware already
programmed into the flash memory. Note that you must install an approved
SDRAM ECC DIMM into the memory socket prior to SRCU31 installation.
Refer to the approved memory list at
http://support.intel.com/support/motherboards/server/srcu31
WARNING
SHOCK HAZARDS may be present inside the unit in which this card
is being installed. Disconnect all power cords to the unit before
removal of any covers.
Follow the warnings noted in your computers user or service
manual before installing this board. ONLY after all the covers are
reinstalled should you reattach the power cords and power up the
unit for the software installation and use.
1 Power down the system, disconnect power cord(s) and remove the system
cover.
2 Install the SRCU31 into an available PCI slot. Connect one end of the SCSI
cable to the internal (68 pin) or external (VHDCI) SCSI connector on the
SRCU31. Connect the other end of the SCSI cable to the SCSI drives or
drive enclosure.
3 Replace the system cover, reconnect power cord(s).
✏ NOTE
SRCU31 will work in a 32 bit slot, however, a 64 bit, 33 MHz PCI slot is
recommended. Consult the system guide for the target server board to
determine an appropriate 64 bit, 33 MHz PCI slot.
✏ NOTE
Ensure that the end of the SCSI bus is properly terminated. Consult the
documentation for the drives or drive enclosure for termination details.