Filter
Top Products
9
n Storing an Autodial Entry
1 Press the key programmed as Autodial Programming.
2 Press / (if the key assignment list selection is congured as “Enabled”)
or <B/C> to select a memory location number.
3 Press S to enter a name for the list number.
4 Press / to select a digit.
5 Press C> to accept the entered digit and move the cursor to the right.
• Press A or # to delete an incorrect digit. Press and hold A or # to delete all
digits.
6 Repeat steps 4 and 5 to enter the entire name.
7 Press S to accept the name and enter a number.
8 Press / to select a digit.
• You can also enter digits directly using the keypad.
9 Press C> to accept the entered digit and move the cursor to the right.
• Press A or # to delete an incorrect digit. Press and hold A or # to delete all
digits.
10 Repeat steps 8 and 9 to enter the entire number.
11 Press S to accept the number and store the entry.
n Removing an Autodial Entry
1 Press the key programmed as Autodial Programming.
2 Press / (if the key assignment list selection is congured as “Enabled”)
or <B/C> to select a memory location number.
3 Press A or #.
• “DELETE” appears on the display.
• Additionally, you can press and hold
A or # to delete all entries.
4 Press S or to conrm the deletion.
rediAling
1 Press the key programmed as Autodial.
2 Press , then 0.
• If there is no data in the redial memory, an error tone will sound.
3 Press the PTT switch to make the call.
Stun
This function is used when a transceiver is stolen or lost. When the transceiver
receives a call containing a stun code, the transceiver becomes disabled. The
stun code is cancelled when the transceiver receives a call with a revive code.
• “STUN” appears on the display while the transceiver is stunned.