Filter
Top Products
11
FleetSync: ALPHANUMERIC 2-WAY PAGING FUNCTION
FleetSync is an Alphanumeric 2-way Paging Function and is a protocol owned by
Kenwood Corporation.
Note: If set up by your dealer, your transceiver may use the MDC-1200 feature in place of
FleetSync. MDC-1200 and FleetSync cannot be operated simultaneously.
SelcAll (SelectiVe cAlling)
A Selcall is a voice call to a particular station or to a group of stations.
n Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Selcall or Selcall + Status.
3 Press / (if the key assignment list selection is congured as “Enabled”)
or <B/C> to select the ID of the station you want to call.
• You can also enter the station ID directly by using the keypad.
4 Press the PTT switch and begin your conversation.
• You can also press n to page the ID, rather than talking.
n Receiving
If enabled by your dealer, an alert tone will sound and the LED will blink when
a Selcall has been received. To respond to the call, press the PTT switch and
speak into the microphone.
n Identification Codes
An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.
Each transceiver must have its own Fleet and ID number.
Note: The ID range may be limited by programming.
pAging cAll
1 Select your desired zone and channel.
2 Press the key programmed as Paging Call to transmit your PTT List ID, to
request a call.
StAtuS meSSAge
Status messages are 2-digit codes ranging from 10 to 99 (80 ~ 99 are reserved
for special messages).
A maximum of 15 received messages can be stored in the stack memory of your
transceiver and can be reviewed after reception. The icon appears when a
message is stored in the stack memory.