Filter
Top Products
36
&20081,&$7,1*$,'6
$872&:7;,166%02'(
If you operate both SSB and CW modes, you can
configure the transceiver to change the operating
mode from SSB (USB or LSB) to CW and then
transmit in CW mode automatically when you operate
the CW keyers.
The mode automatically changes from USB to CW
and LSB to CWR, regardless of the setting for Menu
No. 42 (Frequency correction for changing SSB to
CW). Therefore, when the CW signal is received in
SSB mode, you can operate the paddle or keyer to
immediately communicate CW with another station.
1 Press [MENU], then press [Q-M.IN]/ [Q-MR] or
turn the MULTI/CH control to access Menu No. 41.
2 Press [M.IN] to select “on”.
3 Press [MENU] to exit Menu mode.
Note: You must switch the CW Break-in function ON to change
the mode and transmit in CW mode {page 32}.
0,&83':1.(<3$''/(02'(
This function allows you to send CW messages
without using an optional paddle {page 2}. The Mic
[UP] key can be used as the dot paddle and the Mic
[DWN] key can be used as the dash paddle.
To activate Mic UP/ DWN key Paddle mode:
1 Press [MENU], then press [Q-M.IN]/ [Q-MR] or
turn the MULTI/CH control to access Menu No. 40.
2 Press [M.IN] to select “PA”.
3 Press [MENU] to exit Menu mode.
• Press and hold Mic
[DWN] to send dots or Mic
[UP] to send dashes in CW mode.
4 To exit Mic UP/ DWN key Paddle mode, access
Menu No. 40 and select “PF”.
6:$3'27$1''$6+3$''/(326,7,216
This function reverses the position of the dot and dash
paddle positions. As a default, the left paddle sends
dots and the right paddle sends dashes. When this
function is ON, the left paddle will send dashes and
the right paddle will send dots.
1 Press [MENU], then press [Q-M.IN]/ [Q-MR] or
turn the MULTI/CH control to access Menu No. 39.
2 Press [M.IN] to select “on”.
3 Press [MENU] to exit Menu mode.
• The left paddle now sends dashes and the right
paddle now sends dots. To return to the normal
paddle positions, access Menu No. 39 and
select “oFF”.