Filter
Top Products
15
TEMPORARY STORAGE FOR THE EARTH AUGER WHILE ON THE JOB SITE
The earth auger can be temporarily stored on the job site by one of the following acceptable methods.
a) Digging a shallow hole and leaving the earth auger connected to the auger with the engine
not running.
b) Disconnecting the earth auger from the auger bit, and storing it in a level configuration with
its muffler and engine spark plug upward.
c) Storing the earth auger while connected to the auger bit with the muffler and the engine
spark plug facing upward.
Pay attention that the hot muffler and muffler heat shield do not ignite grass or other com-
bustible materials.
CAUTION:
• Before doing any work on the equipment, always stop the engine and pull the plug cap off the spark plug (see “checking the spark plug”).
• Always wear protective gloves!
To ensure a long service life and to prevent any damage to the equipment, the following servicing operations should be performed at regular inter-
vals.
Daily checkup and maintenance
– Before operation, check the machine for loose screws or missing parts. Pay particular attention to stability of the auger pin and safety pin.
– Before operation, always check for clogging of the cooling air passage and the cylinder fins.
Clean them if necessary.
– Perform the following work daily after use:
• Clean the equipment externally and inspect for damage.
• Clean the air filter. When working under extremely dusty conditions, clean the filter the several times a day.
• Check that there is no deformation or cracks on the auger bit and make sure they are firmly mounted by the auger pin and safety pin.
• Check that there is sufficient difference between idling and engagement speed to ensure that the auger bit is at a standstill while the engine is
idling (if necessary reduce the idle speed). If under idling conditions the tool still continues to run, consult your nearest service center.
– Check the functioning of I-O switch and throttle control.
SERVICING INSTRUCTIONS