Filter
Top Products
PAGE 20 —GB4000 BALLOON LIGHT• OPERATION AND PARTS MANUAL — REV. #1 (02/25/14)
LAMP ADAPTER PLATE MOUNTING INSTALLATION
1. Remove the adapter plate kit hardware from its
container.
2. Before proceeding make sure the light tower mast is
in the stow position (down) and the cradle lock/release
pin has been inserted and the mast is locked.
3. Attach the lamp adapter plate to the T-Bar as shown
in Figure 7. Align adapter plate so that adapter spacer
notch fits over screw on T-Bar. Pay close attention to
the orientation of the two support brackets.
4. Mount the flat end of both support brackets flush
against the T-Bar with the low end of each bracket
facing inwards toward the mast. The raised end of
each bracket should be facing outward.
NOTICE
Pay close attention to the orientation of the two support
brackets. Each bracket has a high and low side. The low
side of the bracket should be facing inwards towards
the mast.
SETUP
5. Next, insert a bolt (4) and flat washer (4) thru the
mounting holes on the adapter plate as shown in Figure
7. Again, pay close attention on which set of holes to
insert the bolts thru. Bolt number 2 must be oriented
so that it passes between receptacles J1 and J2 on
the T-Bar.
6. Secure the adapter plate to the T-Bar using the supplied
flat washer (4), lock washer (4) and nut (4). Make sure
the adapter plate is level (use a bubble level) and both
brackets are straight (vertical), not slanted, before
tightening.