Filter
Top Products
PAGE 24 —GB4000 BALLOON LIGHT• OPERATION AND PARTS MANUAL — REV. #1 (02/25/14)
OPERATION
REMOVING BALLOON PROTECTIVE COVER
1. Expose the balloon by unsnapping the buttons and
unzipping the protective cover as shown in Figure 11.
Figure 11. Removing Protective Cover
2. Next, fold the protective cover into itself and zip. See
Figure 11.
INFLATING BALLOON AND TURNING ON LAMPS
(LT12 ONLY)
1. On LT12 series light towers, reconnect negative battery
cable (black).
2. Slightly raise the light tower mast to allow clearance
for the balloon to inflate.
3. Start the light tower engine as referenced in the LT12
light tower operation manual.
CAUTION
DO NOT use excessive force when
zipping or unzipping the balloon. The
possibility exists of the zipper tearing,
which would make the balloon unusable.
BALLOON
FULLY
EXPOSED
UNZIP
PROTECTIVE
COVER
SNAPS
FOLD PROTECTIVE
COVER INTO ITSELF
4. Once, the engine has started, place the main circuit
breaker switch (Figure 12) on the LT12 control panel
in the ON position.
Figure 12. Main Breaker ON (LT12)
5. Next, turn on lamp circuit breakers. The balloon should
begin to inflate and the lamps will light.
6. Secure any unused lamp cables.
7. Raise the light tower mast to the desired upright height.
LIGHT CONTROL/BREAKER
120 VAC/15A
GFCI
BREAKER
240 VAC/30A
MAIN
BREAKER
CB4
CB3CB2
CB1
LT12
LIGHT TOWER
MAIN
CIRCUIT
BREAKER
ON