Filter
Top Products
40
ATOM 3.0 OPERATING MANUAL
© 2002 Design, 2011 Doc. No. 12-5216-r02 (9/6/11)
GAUG DIVE MAIN, information includes (Fig. 129) -
> Current Depth with FT (or M) icon.
> Run Timer (min:sec), if selected for display, up to 199:59.
> Elapsed Dive Time with EDT and min icons, up to 999 if no Run Timer; or up to 99 if the Run Timer is displayed.
> Tank Pressure with Link, PSI (or BAR), Tank (TMT) icons.
> Air Time Remaining with ATR and min icons.
> VARI (while ascending).
• A (< 2 sec) - to access ALT.
• M (2 sec) - to access TMT Switching.
• S (< 2 sec) - to acknowledge/silence alarms.
• S (< 2 sec)* - to start/stop Run Timer, if displayed.
• S (2 sec)* - to reset Run Timer to 0:00, if active.
• L (press) - to activate Backlight.
*S operations of the Run Timer are blocked during Switching and alarms.
Upon ascending to 2 FT (0.6 M) during a dive, Surface Interval time will be displayed with the SURF icon flashing for the first 10
minutes (Fig. 130). The Run Timer will remain active if displayed, then stop and reset to 0:00 after 10 minutes.
>> Button operations are as described above.
>> After 10 minutes elapse, operation will revert to the Surface Main and full access will be given to GAUG Surface items.
>> If a descent is made to 5 FT (1.5 M) for 5 seconds, the dive will be continued.
>> Surface time will not be added to Dive Time.
Once a dive is completed in Gauge Mode,
operation will lock into Gauge Mode for 24 hours.
GAUG DIVE ALT, information includes (Fig. 131) -
> Max Depth with MAX and FT (or M) icons.
> Time of Day (hr:min_sec), with AM (or PM) icon if 12 Hour.
> Temperature with ° icon and graphic F (or C).
• 5 sec or A (< 2 sec), revert to Main.
DV 3 (DELAYED VIOLATION 3)
If you descend deeper than the MOD*, the audible will sound and the alarm LED will flash. The graphic UP will flash in place of
Current Depth (Fig. 132), and Max Depth will only indicate dashes signifying that you are too deep.
*MOD is the Max Operating Depth at which the unit can properly perform calculations or provide accurate display information. Refer to the specifications in the
back.
Upon ascending above the MOD, Current Depth will be restored, however, Max Depth will continue to be displayed as dashes
for the remainder of that dive. The Log for that dive will also display dashes for Max Depth.
Fig. 130 - GAUG DIVE MAIN
(during < 10 min on surface)
Fig. 129 - GAUG DIVE MAIN
Run Time
(min:sec)
- or -
Fig. 132 - GAUG DIVE DV 3
Fig. 131 - GAUG DIVE ALT