Filter
Top Products
Symptoms, Possible Causes and Solutions
Planar UltraRes User Manual 146
Symptom: My Scheduled Network Power On/Off Settings Aren’t Working
Possible Cause
The Standby Mode setting in the UltraRes Control software may not be set to Fast
Startup. If the Standby Mode is not set to Fast Startup, the LAN module power will be
disabled in standby. Also, when then scheduler powers off the system, it won’t be
able to power back on later if Standby Mode is set to Low Power.
Solution
Make sure Standby Mode is set to Fast Startup in the UltraRes Control software. See
"Standby Mode" on page 68 for more information.
Symptom: IR Isn’t Working Properly
Possible Cause
The wired IR module may not be fully connected.
Solution
Make sure the IR is fully connected by pressing hard to unsure it is inserted as far as
possible.
Possible Cause
The wired IR module cable is not being used.
Solution
Make sure that the wired IR module cable. See "Connecting the Wired IR Module" on
page 39 for more information.