Filter
Top Products
Step 5: Install the Rudder Position Sensor 27
Step 5
10. Tighten the hose clamps around the bullhorn ram and the rudder
sensor’s barrel.
11. Tighten the starboard bullhorn bolt to secure the U-bracket.
12. Fit and tighten the supplied nut and washer to secure the threaded
rod end of the sensor’s shaft to the U-bracket.
Note: We recommend installing the sensor with its shaft pointing to
starboard. If you cannot install the unit in this orientation, you can fit
it with the shaft pointing to port. If you do this, swap the red and green
connections at the course computer.
Linear rudder position sensor - installation
Connecting to the course computer
1. Route the cable to the course computer, taking into account the
EMC installation guidelines (page 7).
2. Connect to the
RUDDER terminals on the course computer (refer
to the illustration on page 25).
Note: To allow for the bullhorn’s movement, leave a loop of cable at
the end of the linear rudder position sensor. If the standard cable is
not long enough, your Raymarine dealer can supply a 10 m (30 ft)
extension cable (part number: D173).
D5390-1
End
bracket
Cable
Bullhorn
ram
Spacer
Sensor
barrel
Hose clamp
Alignment mark
Sensor
shaft
U-bracket
Nut and
washer
Bullhorn
ram shaft
Starboard
bolt
Threaded
rod
Sensor
shaft
Sensor
barrel
81173_3.book Page 27 Thursday, June 7, 2001 11:51 AM