Filter
Top Products
3-20
RayChart 420/420D Chartplotter
3. Use trackpad up/down to select the required destination and press ENTER
to start the GoTo, or CLEAR to cancel the operation.
The operation is conducted in the same manner as for GO TO PORT above.
Stop follow or stop goto
To stop following the route or target point:
1. Either press the GOTO key or move the cursor over the target waypoint.
2. Select the STOP GOTO or STOP FOLLOW function respectively:
D4689_1
STOP
GOTO
RESTART
XTE
D4688_1
STOP
FOLLOW
RESTART
XTE
WAYPOINT
ADVANCE
The dotted line from your vessel to the target waypoint disappears.
3.5 Changing the display mode
Use the PAGE key to select the required display mode. Repeat presses of the
PAGE key provide the following display modes:
• Set Up functions (see Chapter 4)
• Course Deviation Indicator (CDI)
• Bearing & Distance Indication (BDI)
• Waypoint data
• Navigation data
• Time/Date data
• Return to Set Up functions
Note: Press GOTO in any display mode to return to normal Chart display.
To change the display mode:
1. Press the PAGE key to show the SET UP functions with SYSTEM SET
UP highlighted:
D4699_1
SYSTEM
SETUP
CHART
SETUP
TRACK
SETUP
GPS
SETUP
2. Repeat Step 1 to cycle through each of the available display modes.
Note: The Set Up Function Bar remains displayed in each display mode.
To remove the Set Up Function Bar, press CLEAR.