Filter
Top Products
930-112-01-D.00 PowerLogic
TM
Series EM4000/EM4800
11/2013
©2013 Schneider Electric All Rights Reserved 21
Meter Points (Circuits) Tab
The Meter Points (Circuits) tab contains the configuration information for each of
the metering points. It shows the number of elements used, the phase, the current
ratings, and the user-defined identification string for each meter point. Default
information is entered when the metering configuration is selected in the
Manufacturing Tab (see “Manufacturing Tab” on page 19).
Meter Point Configuration
The current rating and phase assignment for each meter point can be configured
individually, by meter, or all at once. The configuration in all three cases does not
take effect until the new settings have been sent to the meter (see “Completing the
Meter Configuration” on page 26).
To change the current rating and phase assignment for an individual meter point:
1. Select one probe at a time from the Meter Points (Circuits) List. The selected
probe number will appear in the middle pane beside Probe, and its assigned
Current and Phase are shown beneath it. See Figure 14.
2. To change the Current, enter the required number. To change the Phase,
select the required phase type from the pull-down list.
Figure 14: Meter Points configuration screen