Filter
Top Products
GPS chartplotters Page 31
1. Press [MENU] , select SETUP and press [ENTER] or move the shuttlepoint knob to the
right.
2. Move the ShuttlePoint knob to
GENERAL SETUP and press [ENTER] or move the
ShuttlePoint knob to the right.
3. Move the shuttlepoint knob to
TIME SETUP and press [ENTER] or move the
shuttlepoint knob to the right.
4. Move the shuttlepoint knob to
GPS TIME OFFSET and press [ENTER] or move the
shuttlepoint knob to the right.
5. Move the ShuttlePoint knob down to select +00:00 , press [ENTER] and move the
ShuttlePoint knob to the right to edit the number.
6. Look at the table and find the offset for your area. You will need to enter this offset to
make the GPS chartplotter show the correct time.
7. Move the Shuttlepoint knob the “+”. Move the ShuttlePoint knob up or down to change
to the desired offset.
8. Next move the ShuttlePoint to the right to select Hours and move the ShuttlePoint up
or down to change the hour.
9. Repeat this method to change the minutes if necessary.
10. Once you have the correct GPS time offset, press [ENTER] to set.
3.3 SELECTING LORAN TD OR OTHER COORDINATE SYSTEM
The GPS Fix coordinates can be changed to show Latitude/Longitude, Loran TD’s or UTM.
Below is the window that will appear when customizing the coordinate system.
Figure 3.3 - Coordinate System Menu
1. Press [MENU] and move the ShuttlePoint knob to select SETUP.
2. Move the ShuttlePoint knob to
ADVANCED SETUP and press [ENTER] or move the
ShuttlePoint knob to the right.
3. Move the shuttlepoint knob the select
NAVIGATE.
4. Press [ENTER] or move the ShuttlePoint knob to the right and select
COORDINATE
SYSTEM.
5. Press [ENTER] or move the ShuttlePoint knob to the right to show the coordinate
selection popup window.
6. Move the ShuttlePoint knob to highlight the desired coordinate type and press [ENTER]
or move the ShuttlePoint knob to the right.
7. Press [CLEAR] or move the ShuttlePoint knob to the left until the chart page is shown.
NOTE
If the TD is selected, you should set the Chain, Pair, ASF1, ASF2 and Alter. If the TD numbers are