Filter
Top Products
Page 58 GPS chartplotters
Landmarks On On Off Off
Cultural Features On Off Off Off
Lat/Lon Grid On Off On Off
Chart Boundaries On Auto Off Off
Cartography On On Off On
Mixing Levels On Off On Off
Objects Overlap Off On Off On
1. To change to one of the pre-programmed settings, press [MENU] and move the
Shuttlepoint knob to highlight
SETUP and press [ENTER].
2. Move the ShuttlePoint knob to
CHART SETUP and press [ENTER].
3. Move the Shuttlepoint knob to
PRESETS and press [ENTER].
4. Move the ShuttlePoint knob up or down to select the desired preset and press [ENTER].
5. Press [CLEAR] or move the ShuttlePoint knob to the right until the Chart Page is shown.
10.0.4 Advanced Chart SetUp
The GPS Chart plotter also allows you to customize all the chart settings. The next sections
will describe all the selections that can be customized.
Figure 10.0.4 - Advanced Chart SetUp
10.0.4.0 Marine Settings Menu
The Marine setting menu controls the details shown from an optional C-MAP NT or NT
+
C-CARD. Selections included US or International Nav-Aids, Tide and Currents, and Light
Sectors can be enabled to disabled from this menu.
Names : Enables or disables the display of names of areas on the land and water. The default setting is on.
Nav-Aids : Lights, Signals, Buoys and Beacons are displayed differently on maps around the world. This
selection allows the Nav-Aid to be displayed to your preference. Selections are
US : Draws Nav-Aids using NOAA Symbols. Default setting.
US simple : Shows complex objects as one icon only. This selection may be preferred if the
screen becomes cluttered.
INT : Draws Nav-Aids using International Symbols
INT Simple : Shows complex objects as one icon only. This selection may be preferred if the
screen becomes cluttered.
Off : Turns off all Nav-Aids.
Light Sectors : Enables or disables the light sectors shown on the display.
Attention Areas : Enables or disables the display of Attention areas( areas which special attention by the mariner
is required, due to some natural or manmade hazards or sailing regulations and restrictions.)
Tides & Currents : Enables or disables the display of Tides and Currents.
NOTE
When Tide and Current display is disabled the Tide Station search cannot be activated.