Filter
Top Products
GX2360SPage 20
[
WX
]
Key
Immediately recalls the previously selected NOAA weather channel from
any channel.
Secondary use
1. Holding down the
[
16/9
]
key while pressing the
[
WX
]
key changes the
mode from USA to International or Canadian.
2. Holding down the
[
WX
]
and
[
SCAN
]
key while turning the power on
resets the microprocessor and erases scan channels from memory.
This clears the memory and establishes the factory-set defaults. For
a list of these defaults, see the section on 6.23 Resetting the
Transceiver’s Microprocessor.
[
A/B
]
Key
Immediately recalls two user assigned channels from any channel.
[
DW
(
IC
)]
Key
Scans for voice communications on CH16 and another selected channel
until a signal is received on either channel. (Dual watch)
NOTE: When the DSC SCANNING feature is enabled (see section 7.3
DSC SCAN), the radio watches for a transmission on CH16, another
selected channel, and CH70 until a signal is received (Triple watch).
Secondary use
Press and hold
[
DW
(
IC
)]
key, when the optional RAM+ Mic is connected,
intercom operation will operate between radio and RAM+ Mic.
[
H/L
(
NAV
)]
Key
Toggles between 25 W (High) and 1 W (Low) power. When the
[
H/L
(
NAV
)]
key is pressed while the transceiver is on channel 13 or 67, the power
will temporarily switch from LO to HI power until the PTT is released. The
[
H/L
(
NAV
)]
key does not function on transmit inhibited and low power
only channels.
Secondary use
Press and hold
[
H/L
(
NAV
)]
key, the LCD displays NAV GPS Data, Time,
SOG (Speed Over Ground), and COG (Course Over Ground) when a
GPS is connected to the accessory cable of the QUANTUM. See sec-
tion 4.4 CONNECTION OF GPS WITH NMEA OUTPUT.
[
SCAN
]
Key
1. Starts and stops scanning of programmed channels.
2. If held while the
[
UP
(
)]
or
[
DOWN
(
)]
key on the microphone are
pressed or CHANNEL selector knob on radio is turned, the radio will
show the channels programmed in scan memory. This function will
not work if the unit is scanning.