Filter
Top Products
GX2360SPage 58
Watches for a transmission on CH16 and another selected channel until
either signal is received. (Dual watch)
NOTE: When the DSC SCANNING feature is enabled (see section 7.3
DSC SCAN), the radio watches for a transmission on CH16, another
selected channel, and CH70 until either signal is received (Triple watch).
Secondary use
Press and hold
[
DW
]
key, intercom operation will operate between radio
and RAM Mic.
[
NAV
]
Key
Press this key, when connected to the GPS receiver, the LCD displays
Position Data, Time, SOG (Speed Over Ground), and COG (Course Over
Ground) from the GPS.
Secondary use
Press and hold
[
NAV
]
key to access PA/FOG function menu.
[
WX
]
Key
Immediately recalls the previously selected NOAA weather channel from
any channel location.
Secondary use
1. Holding down the
[
16/9
]
key while pressing the
[
WX
]
key changes the
mode from USA to International or Canadian.
NOTE: If position is displayed, this icon will be hidden.
2. Holding down the
[
WX
]
and
[
SCAN
]
key while turning the power on re-
sets the microprocessor and erases scan channels from memory. This
clears the memory and establishes the factory-set defaults. For a list of
these defaults, see the section on Resetting the Transceiver’s Micro-
processor.
[
DISTRESS
]
KEY
Used to send a DSC Distress Call. To send the distress call:
1. Lift the red rubber cover.
2. Press and hold the Red button. The RAM+ display will count down (3-2-
1) and then transmit the Distress call.
3. When the distress signal is sent, Ch70 and “TX” icon will
appear on the LCD. After the message has been sent,
the radio will sound a Distress Alarm.
4. The transceiver “shadow-watches” for a transmission on
CH16 or CH70 until an acknowledgment signal is re-
ceived. “DISTRESS” and “WAITING” will appear on the
LCD.
5. If an acknowledgement is received, select channel 16