Filter
Top Products
GX2360SPage 36
7.2.2 Programming the MMSI
WARNING
User MMSI can be input only twice. If the user tries to input MMSI more
than twice, the radio will show the display on the
right. If the user needs to change the MMSI more
than twice, the transceiver will have to be sent to
Factory Service. Refer to the section 10.2 FAC-
TORY SERVICE.
Allowing a user to program the MMSI only two times is a FCC requirement that
STANDARD HORIZON has to follow.
1. Press and hold down the
[
CALL/SET
(
MENU
)]
key
until the “RADIO SETUP” menu appears.
2. Turn the CHANNEL selector knob to the left to se-
lect “DSC SETUP” menu.
3. Press the
[
CALL/SET
(
MENU
)]
key, then select
“USER MMSI” with the CHANNEL selector knob.
4. Press the
[
CALL/SET
(
MENU
)]
key. The “User
MMSI” number will appear, and the first space will
flash.
5. Turn the CHANNEL selector knob or press the
[
UP
(
)]
/
[
DOWN
(
)]
key on the microphone to se-
lect the first number of your MMSI, then press the
[
CALL/SET
(
MENU
)]
key to step to the next number.
6. Repeat step 5 to set your MMSI (up to nine digits).
7. When finished programming the number, press and
hold the
[
CALL/SET
(
MENU
)]
key to store the number in memory.
8. To exit this menu and return to radio operation mode press the
[
16/9
]
key.
7.3 DSC SCAN
When the radio is shipped from the factory it is programmed so CH70 (the DSC
channel) is scanned at all times. A selection is provided in the SETUP MENU to
disable the DSC SCAN. Turning off DSC SCAN will disable the radio from re-
ceiving DSC calls (i.e.: Distress Call, Individual Call, All Ships Call, and Position
Requests). If you want to use any of the functions the selection must be left ON.
To Change DSC SCAN Method:
1. Press and hold down the
[
CALL/SET
(
MENU
)]
key
until “RADIO SETUP” menu appears.
2. Turn the CHANNEL selector knob to select “DSC
SETUP” menu.