Filter
Top Products
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
5.9.5. Setting the sample rate
The sample rate controls how oftenthe depth, time, tank pressure, and water temperature
is stored in the memory.
You can set the dive profile sample rate to 10, 20, 30, or 60 seconds. The factory default
setting is 20 seconds.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
5.9.6. Setting the tank pressure alarm
The tank pressure alarm can be set "ON" or "OFF" and in the range of 10 - 200 bar. The
alarm is the secondary cylinder pressure alarm point. The alarm is activated when the
tank pressure drops below the set limit. You can acknowledge this alarm.
The 50 bar alarm, however, is fixed and cannot be changed. You cannot acknowledge
this alarm.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
5.9.7. Setting the tank pressure
The wireless transmission can be set “ON” or “OFF” depending whether the wireless
pressure transmitter is used or not. No cylinder pressure-related data is shown, nor data
reception made, when this selection is “OFF”.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
5.9.8. Setting the HP code
The HP Code setting allows you to verify the selected code and to erase the stored code.
It also enables re-pairing if necessary.
21