Filter
Top Products
CHANGING GAS MIX. SCROLL
THROUGH ENABLED MIXES BY
PRESSING THE UP OR DOWN
BUTTONS. SELECT NEW MIX BY
PRESSING THE SELECT BUTTON.
NOTE
Mix number, O
2
%, He% and PO
2
for the mixes are shown when
scrolling. If the set PO
2
limit is exceeded , it will be shown with the
PO
2
value blinking. The dive computer does not allow you to change
to a gaswhose set PO
2
is exceeded. Insuch a case,the mix is shown
but cannot be selected. If the PO
2
is less than 0.18 bar, the dive
computer gives an alarm.
NOTE
If no button is pressed in 15 seconds, the dive computer will go back
to the dive display without changing the gas mix. Upon ascent, the
computer prompts you to change gas when the PO
2
level you have
set for the next mix allows a gas change. The prompt is an audible 3
beeps and the current O
2
or O
2
: He mix starts to blink.
6.3. Diving in GAUGE mode
If set to GAUGE mode, the dive computer can be used as a bottom timer.
In the GAUGE mode, the total dive time is always displayed in minutes in the lower right
corner. In addition,a Dive Timer in the centerwindow displays time in minutes andseconds.
The center windowDive Timeris activated at the startof the dive andit can be reset during
the dive and used as a stopwatch by pressing the SELECT button.
BY PRESSING THE SELECT BUTTON DURING A DIVE, A BOOKMARK
IS WRITTEN IN THE PROFILE MEMORY, THE DIVE TIMER IS RESET,
AND THE PREVIOUSLY-TIMED INTERVAL IS DISPLAYED BELOW.
Tank pressure (if enabled) is also displayed during the dive.
NOTE
The GAUGE mode does not provide decompression information.
NOTE
If you divewith the GAUGEmode, it is not possibleto change between
the modes before the no fly time (48 h) has counted down.
33