Filter
Top Products
8. CARE AND MAINTENANCE OF MY SUUNTO DIVING COMPUTER
The SUUNTO dive computer isa sophisticated precision instrument. Althoughit is designed
to withstand the rigors of scuba diving, you must treat it with the same proper care and
caution as any other precision instrument.
•
WATER CONTACTS AND PUSH BUTTONS
Contamination or dirt on the water contacts/connector or push buttons may prevent
the automatic activation of theDive Mode and cause problems during the data transfer.
Therefore, it is important that the water contacts and push buttons are kept clean. If
the water contacts are active (AC text remains on display) or the Dive Mode activates
on its own, the reason for this is probably contamination or invisible marine growth,
which may create an electric current between the contacts. It is important that the dive
computer is carefully washed in fresh water after the day’s diving is completed. The
contacts can be cleaned with fresh water and, if necessary, a mild detergent and a soft
brush. Sometimes it might be necessary to remove the instrument from the protective
boot for cleaning.
•
CARE OF YOUR DIVE COMPUTER
NEVER try to open the case of the dive computer.•
• Have your dive computer serviced every two years or after 200 dives (whichever
comes first) by an authorized dealer ordistributor. Thisservice will include a general
operational check, replacement of the battery, and water resistance check. The
service requires special tools and training. Therefore, it is advisable to contact an
authorized SUUNTO dealer or distributor for the biennial service. Do not attempt
to do any servicing that you are not sure of.
• Should moisture appear inside the case, immediately have the instrument checked
by your SUUNTO dealer or distributor.
• Should you detect scratches, cracks or other such flaws on the display that may
impair its durability, immediately have it replaced by your SUUNTO dealer or dis-
tributor.
• Wash and rinse the unit in fresh water after every use.
• Protect the unit fromshock, extreme heat, direct sunlight, and chemical attack. The
dive computer cannot withstand the impact of heavy objects like scuba cylinders,
nor chemicals like gasoline, cleaning solvents, aerosol sprays, adhesive agents,
paint, acetone, alcohol, etc. Chemical reactions with such agents will damage the
seals, case and finish.
• Store your dive computer in a dry place when you are not using it.
• The dive computer will display a battery symbol as a warning when the power gets
too low. When this happens, the instrument should not be used until the battery
has been replaced.
• Do not fasten thestrap of your dive computer too tightly. You should be ableto insert
your finger between the strap and your wrist. Shorten the strap by cutting it if you
do not expect to need the extra length.
•
MAINTENANCE
The instrument should be soaked, thoroughly rinsed with fresh water, then dried with
a soft towel after each dive. Make sure that all salt crystals and sand particles have
been flushed out. Check the display for possible moisture or water. DO NOT use the
dive computer if you detectany moisture or water inside. Contact an authorizedSuunto
dealer for battery replacement or other service.
CAUTION!
• Do not use compressed air to blow water off the unit.
• Do not use solvents or other cleaning fluids that might cause damage.
• Do not test or use the dive computer in pressurized air.
•
WATER RESISTANCE INSPECTION
41