Filter
Top Products
10
BUZZER ON / OFF
BUZZER LOCKOUT
MORE SETTINGS
SET DAY
SET HOUR (TIME OF DAY)
SET MINUTE (TIME OF DAY)
DEMAND START SENSE
Buzzer : ON
[Set Parameters]
Buzzer Lockout : OFF
[Set Parameters]
Any key to end
or DOWN for more
Day : MON
[Set Parameters]
Hour : 15
[Set Parameters]
Minute : 30
[Set Parameters]
DS Sense : 6W
[Set Parameters]
This display allows you to select whether the audio alarm sounds during an
overload or other alarm conditions. If set to OFF the buzzer will not sound
during an alarm condition. The alarm condition will still be displayed.
Pressing the UP or DOWN keys will change the setting.
If set to ON, lockout prevents the buzzer from sounding during the lockout
period. See lockout on page 11. Pressing the UP or DOWN keys will
change the setting.
Pressing NEXT DISPLAY or UP keys will save the settings entered and go
back to ‘Displays’. If the DOWN key is pressed, more settings will be
displayed.
Sets the current Day. Use the UP and DOWN keys to set the value.
Set the hours in the current time of day (24 hour time). Use the UP or
DOWN keys to set the value.
Sets the minutes in the current time of day. Use the UP or DOWN keys to
set the value.
This sets the minimum load which will bring the SA41 ON when the
inverter Status is set to STANDBY mode (demand start or pulsing). See
page 5. In most cases the default setting of 6W would be suitable. If there is
a load which the SA41 won't sense then reduce this value until the SA41
starts. Alternatively if there is a small load that keeps the SA41 on then
increase this value. You may need to try a few different settings to find the
most appropriate value for your installation. Use the UP or DOWN keys to
set the value.