Filter
Top Products
4
Now connect the battery cables:
RED = BATTERY POSITIVE (+)
BLACK = BATTERY NEGATIVE (-)
These connections should be tight. If using nuts, bolts and washers, they should be stainless steel. At
this point re-check the connections before proceeding any further.
NOTE:
IF THE SA41 EMITS A PULSING BUZZER SOUND, THE BATTERY LEADS HAVE BEEN
CONNECTED IN REVERSE. IMMEDIATELY DISCONNECT THE LEADS AND RECONNECT
WITH THE CORRECT POLARITY. DO NOT UNDER ANY CIRCUMSTANCES TURN ON THE
BREAKER WHEN THE BUZZER IS PULSING AS PERMANENT DAMAGE TO THE SA41
WILL RESULT.
If all is well, turn the breaker ON, i.e. switch lever UP. If after two (2) attempts the circuit breaker does
not turn on, then check that the battery voltage is between 40 and 68V DC. If the breaker still won't
switch on, refer to the FAULT FINDING section of this manual.