E-19
Uniden MHS126 Radio Owner’s Manual
Mounting the Charger
You can mount the charger on any at surface.
1) Use the two holes at the base of the
charger as a template to mark the
drill holes.
2) Using a 1/8-inch (or 3 mm) drill bit,
drill two holes 1/2 inch (13mm) deep.
3) Use the provided screws to attach
the charger to the surface.
Charging the Battery
Your radio includes a charger and a
rechargeable battery pack. Place your radio
in the charger with the display facing
forward. Make sure that the CHARGE LED
on the charger turns orange.
Cautions:
Use only the battery and charger supplied with this radio.
Using a different charger or battery can damage the radio
and create a risk of re or shock.
The charger is not waterproof. If the charger falls into the
water, unplug it before attempting to remove it from the
water. After you remove the charger from the water, please
contact our Customer Care Line.
Wipe off dirt or shake water from your radio before placing
in the charger if your radio gets dirty or wet.