E-22
Uniden MHS126 Radio Owner’s Manual
Weak signals
No
Squelch
Medium
Squelch
High
Squelch
Strong signals
Noise
Adjusting the squelch sets this threshold level. Increasing
squelch requires a signal to be stronger to be seen as
a transmission. If you set the squelch too high, you will
risk not receiving transmissions that are lower than that
threshold. Reducing the squelch allows weaker signals to
be accepted. However, if you lower the squelch too much,
you will hear white noise all the time
While listening to a channel, press and hold
VOL/SQ to
enter Squelch Setting mode.The
SQUELCH Level
(S0)
number displays on the LCD. Press CHANNEL UP or
CHANNEL DOWN to increase or decrease the squelch levels
(0 - 3). Press VOL/SQ to save the setting.
# Note: Setting the squelch level too high may prevent
you from hearing weaker transmissions. If you are having
difculty hearing a transmission, try setting the squelch
level lower.