122
show 802.1x auth_configuration
by mac address or by port.
Authentication Protocol: Radius_Eap − Shows the authentication
protocol suite in use between the switch and a Radius server. May
read Radius_Eap or Radius_Pap.
Port number − Shows the physical port number on the switch.
Capability: Authenticator|None − Shows the capability of 802.1x
functions on the port number displayed above. There are two
802.1x capabilities that can be set on the switch: Authenticator and
None.
AdminCtlDir: Both|In − Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
OpenCtlDir: Both|In
−
Shows whether a controlled Port that is
unauthorized will exert control over communication in both receiving
and transmitting directions, or just the receiving direction.
Port Control: ForceAuth|ForceUnauth|Auto − Shows the
administrative control over the port’s authorization status. ForceAuth
forces the Authenticator of the port to become Authorized.
ForceUnauth forces the port to become Unauthorized.
QuietPeriod − Shows the time interval between authentication failure
and the start of a new authentication attempt.
TxPeriod − Shows the time to wait for a response from a supplicant
(user) to send EAP Request|Identiy packets.
SuppTimeout − Shows the time to wait for a response from a
supplicant (user) for all EAP packets, except for the Request|Identity
packets.
ServerTimeout − Shows the length of time to wait for a response
from a Radius server.
MaxReq − Shows the maximum number of times to retry sending
packets to the supplicant.
ReAuthPeriod − shows the time interval between successive re-
authentications.
ReAuthenticate: Enabled|Disabled
−
Shows whether or not to re-
authenticate.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display the 802.1x authtication states (stacking disabled):
