Extron Electronics MTPX Plus Series Manual

A SERVICE OF

next previous

Matrix Software, cont’d

MTPX Plus Twisted Pair Matrix Switchers • Matrix Software

5-16

12

14

13

13

This sequence is shown for

example only.

For the MTPX Plus,

the firmware file selected and

shown is “MTPX Plus”.

NOTE

Figure 5-13 — Conﬁrm window

13. If necessary, change the port number in the device port ﬁeld:

• RearpanelRS-232/RS-422port,enter1.

• FrontpanelCongurationport,enter2.

Click the OK button. The Firmware Loader reports, “This process could take

several minutes. Please wait...”, then displays a status bar that shows the

progress of the upload. When the upload is complete, the Firmware Loader

reports “Unit resetting, this can take some time, please wait. ...”, and then “Transfer

complete!”.

N

Firmware upgrades using either serial port can take several minutes.

14. When the Firmware Loader reports, “Transfercomplete!”, click the Exit button

on the Firmware Loader and then again on the port conﬁguration window.

The Firmware Loader and the Matrix Switchers Control Program exit.