Bump Mode — While the boat is underway and is in a
safe area that will allow maneuvering, and while the con-
trol handles are both in gear and above the engine idle
speed, demonstrate the “bump up” (speed increment) by
pressing and releasing the WARM button. Repeat several
times.
Demonstrate the “bump down” (speed decrement) by
pressing and releasing the TROLL / SLOW button. Repeat
several times.
Control Head Dimmer — To demonstrate the dim light
capability of the control head lights, press and hold the
WARM and SYNC buttons simultaneously for about 4 sec-
onds.
Restore the control head lights to normal brightness by
pressing and holding the WARM and SYNC buttons simul-
taneously once again, for about 4 seconds.
Station Transfer (multi-station applications) — While
the boat is underway and is in a safe area that will allow
maneuvering, follow the station transfer described in the
Operators Quick Reference Guide and transfer control
from one control station to another.
Try transferring control from one station to another while
at cruising speed, in order to obtain a minimum speed
change.
Each time that the control head buttons are pressed —
either speed increment or decrement — the engine RPM
will increase or decrease approximately 10 RPM.
The different control head light settings and the method of
changing that setting.
EEC3 System Manual
16
