124
Section 1.0 — Name goes Here
39
Section 4.0 — Appendix / Reference
STEP 12: Reinstall control handle and use two set screws, on top of each other.
To mount control handles without Bezel mounting kit:
STEP 1: The control head has one face opposite handle shaft with 1/4 threaded holes to mount to inside face of console.
STEP 2: The 1/4 threaded holes can also be used to mount the control head to a bracket of your design, to attach head
to some other locations in console.
STEP 3: When method of mounting is determined, keep a these things in mind—The length of shaft outside of console
and the free movement of the shaft.
B. Sidemount Keypad Assembly
Before mounting the Sidemount Keypad Assembly, inspect
the surface that the Keypad is to be mounted to. It should be
flat and reasonably strong enough to support the Keypad
securely.
STEP 1: Mark the location for the Keypad Assembly using
the full size template (see page 35). Cut the 1-3/4” x 4” key-
pad assembly cutout.
STEP 2: Insert the connection cable from the Sidemount
Control Handle pod and the Station Cable (that leads to the
Control Processor) through the console cutout and attach to
the keypad assembly. The control head pods are marked
PORT and STBD and must be installed in the proper connec-
tor.
STEP 3: Install Control Head clamps and tighten wing nuts provided. Make sure Keypad Assembly is firmly mounted to
console.
Control Head Clamp
Control Head Clamp
Bottom View
of Sidemount
Keypad
Assembly
Control Head Clamp
Oblique View
of Sidemount
Keypad
Assembly
