Control Process End
Duetsch 8 pos. Grey
ZF Solenoid Valve Connectors
- with LED indicators
Batt Pos.
Batt. Neg.
Transmission Harness
Part # 11604-L1-xx' with LED indicators
(5'- 30' lengths avail. in 5' increments)
xx' in part number represents length of harness
NOTE: Voltage output will be the same as input to CP
Control Process End
Duetsch 4 pos. Black
Cummins Start
Interlock Connector
Deutsch 3 pos.
Start Interlock Harness
Part # 11602-N1-PxxSxx
NOTE: N.C. Circuit between B & C positions.
Circuit OPENS when system is ON and
NOT in Neutral position
8 amp max current
Control Process End
Duetsch 8 pos. Black
Packard Weatherpack
3 pos. Connector
Throttle Signal Harness
Part # 11605-N1-xx'
(5'- 30' lengths avail. in 5' increments)
xx' in part number represents length of harness
C
B
A
Control Process End
Duetsch 4 pos. Black
DC Power Harness
Part # 11601-01 (30' long std.)
NOTE: Power wires are 30' long standard
(custom lengths available)
Battery Positive #1
(Red wire)
Battery Positive #2
(Red wire)
Battery Negative
(yellow wire)
(Noise Supression devices)
(5'- 30' lengths avail. in 5' increments)
Pxx' in part # represents length of harness for PORT side
Sxx' in part # represents length of harness for STBD side
B
C
B
NOTE : A,B,C is molded
into the connector
NOTE : A,B,C is molded
into the connector
Connector is the same on both ends
Station Cable
Part # 11600-02-xx' (available 20' - 100' in 20' increments)
EEC 3 Control System Harnesses - Cummins QSM11 with ZF IRM Transmision
C
Terminating Resistor
Part # 11600-TRF
Two required per system
Connections
A Throttle Reference Voltage - (Green wire)
B Throttle Voltage Signal (White Wire)
C Throttle Reference Voltage + (Red wire)
Control Process End
Duetsch 12 pos. Grey
CP Enable Switch End
- installer provided switch or
- GMP can provide a waterproof rocker switch
with switch namepate
CP Enable Harness
Part # 11603-12-xx' 12v DC system
Part # 11603-24-xx' 24v DC system
Part # 11603-02-xx' 12 or 24v DC system- pinned in the field
(10' - 100' lengths avail. in 10' increments)
xx' in part number represents length of harness
White
Black
NOTE: DO NOT provide power to this end,
only close the circuit using a N.O. switch
