Copy Features
45
Using the 2 Up Feature
Use the following procedure to make a copy using the 2 Up feature:
1. If the DP-C106 is in printer mode, press the Copy button to enter copy
mode.
2. Press the Clear All button to restore default settings.
3. Position the originals in the ADF with the long edge of the paper entering
the ADF first (Long Edge Feed).
You must use the ADF to create a 2 Up copy. For more information on
positioning originals in the ADF, go to the Basic Copying chapter.
4. Select the Paper Supply and the % of Reduction/Enlargement required.
Several common sizes are listed below. Use the Zoom feature to
determine the best reduction for other sizes.
Original Desired 2-Up Output Reduction
8.5 x 11 in. Portrait 8.5 x 11 in. Landscape 64%
8.5 x 11 in. Portrait 11 x 17 in. Landscape 100%
8.5 x 11 in. Portrait 11 x 14 in. Landscape 75%
A4 Portrait A4 Landscape 70%
A4 Portrait B4 Landscape 86%
A4 Portrait A3 Landscape 100%
5. Load paper into the Paper Tray by placing the short edge of the paper to
feed into the machine first (Short Edge Feed).
6. Press the Advanced Features button to display the Advanced Features
selections on the Copier Screen.
7. Use the ( ) ARROW buttons to highlight the 2 Up feature.
8. Press the Select button to display the 2 Up selection on the Copier
Screen.
