Filter
Top Products
35
Northstar 8000i System - 12" Display Processor Installation Manual
Before you cut a hole in a panel, make sure that there are no hidden electrical wires or other
parts behind the panel.
When flush mounting, be sure to mount the 8000i component on a flat surface.
Mounting on a curved surface can result in water leaks around the cutout.
To prolong life of this product, use the supplied sun cover when not in use and during
washdown.
After washdown or use in a wet environment remove excess water from screen
Use the supplied mounting template as a guide to cut a hole in the panel. OBSERVE the
instructions on the template for drill bit and corner hole sizes.
Hold the gasket in place on the back of the unit; the gasket can fit any way round. Hold the
unit in place in the mounting hole and use the supplied screws to secure the unit.
Clip the bezel to the front of the unit; it can fit either way round. The bezel is a tight fit and is
not easy to remove. It is however quite strong and if removal is necessary, gently pull upward
on the bezel by holding the inside edge just above the Northstar logo