Filter
Top Products
70
Northstar 8000i System - 12" Display Processor Installation Manual
2. Select Setup from the control panel.
3. Select
+ Installation to show a list of system installation specification options. (If
you can't see these, select the down arrow to scroll them into view.)
4. Select
Change next to Change Location of Media Storage. A data box appears,
showing a list of all the available 8000i processors.
5. Select the new processor and select
Set Location to confirm the new processor.
The new settings are applied immediately and stay until you change them again.
6. When you are finished, select
Return.
10.9 Set NMEA Output
To select NMEA Output sentences:
1. Select Display.
2. Select
Setup from the control panel.
3. Select
+ Installation to display a list of installation specification options.
4. Select
Configure NMEA output.
5. Select the NMEA output to toggle between
Yes / No
6. Select
Save to confirm the new settings or Return to cancel.
NOTE: It is not possible to select all the parameters at the same time, due to frame rate
timing. Please select only the ones required.
Sentence Output
APA Autopilot (subset of APB)
APB Autopilot Sentence "B"
BEC Bearing and Distance to Waypoint, Dead Reckoning
BOD Bearing, Origin to Destination
BWC Bearing and Distance to Waypoint, Great Circle
BWR Bearing and Distance to Waypoint, Rhumb Line
BWW Bearing, Waypoint to Waypoint
DBT Depth Below Transducer
DPT Depth
GGA Global Positioning System Fix Data
GLL Geographic Position, Latitude/Longitude
HCC basic compass heading
HDG Heading, Deviation and Variation
HDM Magnetic Heading
HDT Heading, True
HSC Heading Steering Command
MWD Wind direction and speed
MWV Wind Speed and Angle
RMB Recommend Minimum Navigation Information
RMC Recommend Minimum Specific GPS / TRANSIT Data
VHW Water Speed and Heading
VTG Track Made Good and Ground Speed