Filter
Top Products
Dakota Ultrasonics
4
2.2 Auto Probe Recognition
When the CMX is initially powered up, the gauge will automatically check to see if the
transducer plugged into the gauge can be recognized. The steps that follow assume
the CMX recognized the probe type:
Probe Automatically Recognized
1) Press the OK key once to use the identified probe, or ESC to display a list of
optional transducers. Note: if the CMX recognizes a specific transducer,
the user should always select OK to use the identified probe. The only time
an alternative probe should be selected from a list is if the user switched
probes following initial power up and recognition.
2) Assuming the CMX recognized the probe and the OK key was pressed, the
CMX will advance to a Zero Probe menu. If the transducer was identified
as a special transducer capable of measuring coating thickness, a menu will
be displayed allowing the user the ability to toggle the coating thickness
display on/off as follows: