Filter
Top Products
CMX High Performance Material & Coating Thickness Gauge
5
3) Press the UP and DOWN arrow keys to toggle the coating option on/off.
4) Wipe all couplant from the transducer face and advance to the Probe Zero
& Calibration section outlined below.
2.3 Selecting the Transducer Type
If the CMX does not identify a specific transducer type on initial power up, the user
will be required to select a type from a predefined list of types by diameter and
frequency. By selecting the transducer type from the predefined list, the CMX can
recall specific properties about the transducer. Note: Once the transducer has been
selected, the CMX will store and recall this transducer type every time the CMX is
powered on/off. The type will only change if the user physically selects another
transducer type from the list, or selects a previously saved setup. However, the CMX
will continue to take you through these steps each time the gauge is powered up.
You’ll notice that the probe type previously selected will be highlighted every time the
probe type screen is displayed. Use the following steps to select your transducer
type: