Filter
Top Products
Parameters Description
Enclose the snapshot virtual disk name in double
quotation marks (" ").
count
The number of repository virtual disks that you
want to remove from the snapshot group. Use
integer values.
Notes
When you use this command, you can specify only one of the parameters. You cannot enter more than
one parameter when you run this command.
Set Storage Array
NOTE: With firmware version 8.10 the cacheFlushStop parameter is deprecated and will be removed
in a future release of storage management software.
Description
The means of registering the iSCSI target on the iSNS server. Set the parameter to TRUE to list an iSCSI
target. When you set this parameter to TRUE you must also use these parameters for IPV4 configurations:
• isnsIPV4ConfigurationMethod
• isnsIPV4Address
When you set this parameter to TRUE you must also use these parameters for IPV6 configurations:
• isnsIPV6Address
Optionally, you can also use the isnsListeningPort parameter to define the port monitor and manage
traffic to the server. To remove the registration for the storage array from the iSNS server set this
parameter to FALSE
Syntax
set storageArray (cacheBlockSize=cacheBlockSizeValue |
cacheFlushStart=cacheFlushStartSize |
defaultHostType=("hostTypeName" | "hostTypeIdentifier")
failoverAlertDelay=delayValue |
mediaScanRate=(disabled | 1-30) |
userRole=(admin | monitor)
password="
password" |
userLabel="storageArrayName"
isnsRegistration=(TRUE | FALSE))
Parameters
Parameter Description
cacheBlockSize
The cache block size that is used by the RAID
controller module for managing the cache. Valid
319