Filter
Top Products
sendbreak(8)
System Administration 121
NAME sendbreak - send a break signal to the specified domain
SYNOPSIS sendbreak -d domain_id
sendbreak [[-q] -{y|n}] -d domain_id
sendbreak -h
DESCRIPTION The sendbreak(8) command sends a break signal to the specified domain.
When a break signal is sent from the domain console to the domain operating
system, control is transferred from the operating system to OpenBoot PROM and
the OpenBoot PROM prompt "ok>" is displayed.
Privileges You must have one of the following privileges to run this command:
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
EXIT STATUS The following exit values are returned:
SEE ALSO console(8), showconsolepath(8)
platadm Can run this command for all domains.
domainadm Can run this command only for your managed domains.
-d domain_id Specifies only one ID of the domain to which to send the break
signal. domain_id can be 0–23 depending on the system
configuration.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-n Automatically answers 'n' (no) to all prompts.
-q Suppresses all messages to stdout, including prompts.
-y Automatically answers 'y' (yes) to all prompts.
0 Successful completion.
>0 An error occurred.