Filter
Top Products
2. WIRING
2-7
5. Fold back the armor by 5 mm, then put it between washers.
Gasket
Vinyl sheath
Clamping gland
Flat washers
Trim the armor with the
width of the washer (5 mm).
5 mm
5 mm
Passing clamping gland, washers and gasket on the signal cable
6. Catch the armor between two flat washers for grounding.
7. Apply sealant 1211 (supplied as installation material) to threads of the clamping gland,
and then fasten it tightly.
8. Determine the length of the cores considering their location on the terminal board TB803,
and then connect cores to TB803 by using the terminal opener.
Procedure
1. Twist the cores.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the core to confirm that it is ecure.
Terminal opener
WAGO Connector
Wire
Twist
Press downward.
Wiring for WAGO connector