Filter
Top Products
2. WIRING
2-12
Shield
Fold back outer con
du
Conduct
or
6
14
5
9
Coaxial cable
Approx. 250
5
30
Unit: mm
Vinyl sheath
Armor
Shield
Fold back the shield.
(30 mm)
2.3 Transceiver Unit
For FCR-2827W/2827W-D
Fabricating of RW-9600
1. Fabricate the RW-9600 cable as
shown right.
2. Trim each wire (except coaxial
cable) considering its location on
the terminal board.
3. Fold back the shield and cut it
leaving 30 mm.
4. Remove insulation of each wire
by about 6 mm.
5. Using the terminal opener, insert
each core (except coaxial cable)
to appropriate connector plug.
6. Insert the coaxial cable to the
TB802 on TB Board and fix the
shield with cable clamp.
Wiring for Coaxial cable
CAUTION
Clamp shied with bracket.
Tighten conductor with screw.
Procedures
1. Twist the conductor.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is ecure.
Terminal opener
Wiring for WAGO connector
WAGO connector
Wire
Twist
Press downward.
Do not use crimp-on lug to prevent
contact resistance from increasing.