Filter
Top Products
7
WAGO connector (for transducer and NMEA ports)
NMEA port
Connect a GPS navigator, etc. to NMEA port J2 #1 to #4. You can connect two sensors (for ex-
ample, GPS receiver GP-310B and smart sensor). One connects to NMEA port J2 #1 to #2 and
the other connects to the NMEA port J2 #3 to #4.
1. Twist conductors.
2. Insert opener and press it down.
3. Insert core to hole.
4. Release opener.
5. Pull the core to confirm that it is
tightly fastened.
Opener (big one: for transducer port
small one: for NMEA port)
Core
Twist.
Press
Wind vinyl tape on sheath.
30
6
Wrap shield about three turns
and cut excess shield.
Wind vinyl tape
on edge of shield.
Solder vinyl wire
to shield.
Extract cores from here and
cut inner materials.
Clamp this parts.
Attach WAGO connector.
Approx. 90
Sheath
Shield
Vinyl tape