Filter
Top Products
15
3.4 NMEA Port Setting
If a GPS navigator and/or other sensor are connected, set up as follows.
1. Press the MENU key.
2. Press T to select "System" and "NMEA" and then press the ENTER key.
NMEA setting menu
3.Press T to select the item to set and then press the ENTER key.
4.Press T or S to select an appropriate one and then press the ENTER key.
Description for each item of the NMEA menu
NMEA0183: Choose NMEA0183 version of navigation equipment connected to the NMEA port,
among Ver. 1.5, Ver. 2.0 or Ver. 3.0. "SPECIAL" is for use with a navigator whose baud rate is
600 bps.
NMEA Port: The NMEA terminals in the NMEA port can function as input ports or input/output
port. Change the setting to "In/In" when connecting GP-310B/320B/330B and a wind sensor.
When connecting the GP-320B/330B and a wind sensor, first turn on "WAAS Setup" and then se-
lect "In/In" as the NMEA Port setting.
• In/Out: NMEA port J2 #1 & #2 is output port and J2 #3 & #4 is input port.
• In/In: NMEA port J2 #1 & #2 changes to input port. (Available with connection of the GP-310B/
320B/330B and a wind sensor.)
NMEA Output: Set the output data sentences.
• Off: Outputs the "output data sentences" created in the FCV-295 (see page 8).
• On: Outputs the "output data sentences" of FCV-295 and sentences which are input from other
equipment.