Filter
Top Products
2-1
WIRING
2.1 Scanner Unit
Preparations
Open the port side cover of the scanner unit to access terminal boards.
Fabricating signal cable S03-80
1. Shorten the cable, extending the length actually required by 800 mm. Strip off
about 600 mm of the anti-corrosive vinyl sheath, and 790 mm of the armor
and the inner vinyl sheath, being careful not to nick the braided shield.
Approx. 800 mm
Anti-corrosive
vinyl sheath
Armor
Approx. 790 mm
Inner shield
Outer shield
Figure 2-1 Fabricating the signal cable S03-80
2. Unravel the outer shield with a screwdriver or similar tool to expose the cores
beneath the outer shield.
3. Similar to step 2, expose the cores beneath the inner shield. Mark all cores
for future identification.
4. Slide the clamping gland, washers and gasket onto the cable. (Use lower side
gland.)
Gasket
Armor
Clamping gland
Washer
Washer
Gland body
Seal with putty
after tightening.
Figure 2-2 Passing clamping gland, washers and gasket on signal cable
5. Ground the armor through the two washers as shown above. Trim the shields
considering their location on the earth terminal inside the scanner unit. Fit a
crimp-on lug (yellow, FV5.5-4, ø4) to inner and outer shields, then connect
them to the ground terminal inside the scanner unit.